Reverie R600 Manuel Du Propriétaire page 8

RADIO FREQUENCY IS 433.92 MHZ
FCC COMPLIANCE
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
To comply with the FCC RF exposure compliance requirements, no change to the antenna or the device is
permitted. Any change to the antenna or the device could result in the device exceeding the RF exposure
requirements and void the user's authority to operate the device.
PRODUCT RATINGS
The lift motor in your Reverie Power Base is NOT designed for continuous use. Reliable operation and full life
expectancy will be attained as long as the lift motor does not operate more than two (2) minutes over an eighteen (18)
minute period, or approximately 10% duty cycle. Any attempt to circumvent or exceed this rating will shorten the life
expectancy of this product and may void the warranty. The recommended weight restrictions for your Reverie Power
Base is up to 850 lbs. total weight, including people and the mattress for all sizes of power bases. Lift speed will vary
due to weight and mattress configuration, as well as the mattress type. The weight must be evenly distributed across
the power base. This Product is not designed to support or lift 850 lbs of total weight in the head or foot sections of
your Reverie power base alone, or in any unevenly distributed fashion. Some mattresses are not designed for Power
Bases because they do not bend or flex well when adjusted. When using such a mattress with your Reverie Power
Base the weight limits set forth herein do not apply, as the bending of the mattress requires significant force and puts
significant strain on the motors and the Power Base itself.
Note: Exceeding the recommended weight restrictions could damage your power base and void your
warranty and using a mattress on top of your power base that is not designed for adjustability may also
void your warranty.
For best performance, you should enter and exit the Power Base while it is in the flat or fully lowered position.
DO NOT SIT ON THE HEAD OR FOOT SECTIONS WHILE IN THE RAISED POSITION.
INTENDED USAGE
The electric power base should be installed with the head board brackets and/or the head of the frame
positioned close to a wall.
All manuals and user guides at all-guides.com
CUSTOMER SERVICE: 800-973-8374
CUSTOMERSERVICE@REVERIE.COM
8
Safety Precautions