Reverie R600 Manuel Du Propriétaire page 20

CONNECTING TO TWO
SEPARATE BEDS
STEP 1
Hold Lightbulb button for 3 seconds to start
searching.
STEP 2
Select Other
STEP 3
The screen now asks if you are connecting to
only 1 bed. Select NO.
STEP 4
There should now be a list of available control
boxes that you can connect to, select the beds
you wish to connect to [remote can show up
to 20 beds] Select any two beds you wish to
connect by single-pressing the lightbulb button.
After selecting 2 beds, the remote will send the
user to the home screen.
FOR PAIRING TWO REMOTES TO
EACH SIDE OF THE BED
[for KING, SPLIT KING or two beds]
Our remote and Bluetooth technology allows for
pairing/connecting two remotes with each side
of the bed so each remote can control both
sides of bed.
Pair/Connect one remote with both sides of the
bed, then wait for that remote to enter sleep
mode and pair/connect the other remote with
both sides of bed.
If two remotes are connected to one bed, in
order to actively use one of the remotes to
control the bed you must make sure the other
remote is in sleep mode. Waking up other
remote will result in a disconnection from the
control unit and the remote will show "No Bed
Paired".
All manuals and user guides at all-guides.com
IMPORTANT NOTE:
•
CUSTOMER SERVICE: 800-973-8374
CUSTOMERSERVICE@REVERIE.COM
20
Bluetooth
Replacement Remote Control
NOTE:
This applies to the king bed situation,
where two remotes are connected to both
sides of the bed.
NOTE: If it cannot detect any beds then
will say NO BED FOUND.
NOTE:
Please remember to recycle all electronics.
To comply with the FCC RF exposure
compliance requirements, no change to
the antenna or the device is permitted.
Any change to the antenna or the device
could result in the device exceeding the
RF exposure requirements and void user's
authority to operate the device.
THIS DEVICE COMPLIES WITH
PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE
FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY
NOT CAUSE HARMFUL
INTERFERENCE (2) THIS
DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE
THAT MAY CAUSE UNDESIRED
OPERATION.
Pairing
®