Publicité
Les langues disponibles
Les langues disponibles
IMPORTANT UNPACKING INSTRUCTIONS
To avoid damage to the power base, always
open the carton while the power base is
laying in the FLAT position on the floor.
OPEN FLAT
STEP 1
Carefully lift the power base unit out of the
shipping carton, keeping the unit top side down.
For safety reasons, this should be performed
by 2 people. Be sure to use a protective layer
under the power base to prevent damage to
your hard floors.
STEP 2
Assembling power base legs: Open the
accessories box, take out the 4 legs,
and thread them in a clockwise direction into
the threaded holes in the frame.
NOTE: Tighten the legs securely to the frame.
Leave no space between the leg and frame.
All manuals and user guides at all-guides.com
Untie and extend the power cord from the frame.
Remove the plastic packaging from the power
base.
Carefully rotate the power base over to the
topside-up position.
Plug the power cord into a grounded electrical
outlet.
CUSTOMER SERVICE: 800-973-8374
CUSTOMERSERVICE@REVERIE.COM
10
Frame Assembly Instructions
STEP 3
WARNING:
POWER CORDS MUST NOT INTERFERE
WITH ANY POWER BASE MECHANISMS.
STEP 4
STEP 5
ATTENTION!
DO NOT
lean the power base
against the installed
legs to flip it over.
STEP 6
NOTE: An electrical surge protection unit is
recommended (not included)
Improper handling
Publicité
