Télécharger Imprimer la page

Reverie R600 Manuel Du Propriétaire page 23

Publicité

Les langues disponibles

Les langues disponibles

Symptom
Remote showing "No Bed Paired"
Distorted image on the remote LED screen.
All functions stopped working due to overload
condition.
Head or Foot Lift function has minor
interference during operation.
Pillow Tilt is not performing normally.
Excessive massage motor noise.
All manuals and user guides at all-guides.com
CUSTOMER SERVICE: 800-973-8374
CUSTOMERSERVICE@REVERIE.COM
23
Solution
Allow the remote to go back to sleep by
setting down, check if its connected after 3
minutes.
If not resolved, go through the pairing
process again.
Let the remote go back to sleep and wake
it up again. Repeat this multiple times. If
problem persists, contact customer service.
Remove the load and reset again by putting
the bed to flat position and then moving it
all the way to maximum position.
Make sure that you are following the duty
cycle of the motors (do not operate more
than three (3) minutes over a thirty (30)
minute period,approximately 10% duty
cycle).
Press the lift buttons squarely & accurately.
Make sure pressing the correct button and
good batteries are in the remote.
Check for obstructions.
If the bed is located on hard surface
flooring, place carpet pieces.
Elevate the head or foot section a short
distance (with the hand control) to realign
the lift/lower mechanisms with the bed
support platform.
Verify that the bed is not positioned against
a wall, nightstand, or other object that may
cause the vibration or noise.
If this base is installed over a bed frame,
verify the massage motors are not causing
the bed frame (or bed frame components)
to vibrate.
Verify that the headboard attachment
hardware is firmly tightened.
Troubleshooting

Publicité

loading