Axis 233D Guide D'installation page 4

Page 4
Install the Hardware
Place dome bubble on camera
1. Place dome bubble on the camera
unit.
2. Place O-ring and black ring with
coordinates over dome. Turn black
ring till it comes into the slots.
3. Different screws are used for
fastening the black ring depending
on which ceiling mount is being
installed:
• Hard Ceiling Mount:
3 recessed screws
• Drop Ceiling Mount:
3 M3x10 screws.
4. Tighten screws to hold ring and
dome securely, do not tighten screws
completely. Follow instructions for
your chosen camera mounting.
Note:
Do not use the camera's dome bubble
if it is to be installed in a protective
housing as the use of two dome bub-
bles will reduce image quality and
cause image blurring.
Top view
Restart
button
(red)
Control
button
(black)
Status
LED
All manuals and user guides at all-guides.com
AXIS 233D Installation Guide
The camera's serial number (S/N) is on
this label. You will need this number to
set the camera's IP address.
There is an additional label included
with this product. Put it in a safe place
for future reference.
Black
ring
O-ring
Dome
bubble
Camera
unit