Axis 233D Guide D'installation page 6

Page 6
D
Insert network camera
into ceiling bracket
Follow these instructions to mount the dome camera:
1. Secure the bracket to the ceiling with four ST4.2 screws and plugs. (Fig. A)
2. Attach one end of the safety wire to the bracket and the other end to the AXIS 233D
using an M4 screw and nut. (Fig. B)
3. Insert four M4 screws (2 screws on each side) partially into the camera base.(Fig. C)
4. Insert the AXIS 233D into the bracket and tighten the captive screw allowing you to
free your hands to tighten the four screws in the screw slots (two on each side) on the
AXIS 233D.(Fig. D)
5. Connect the network cable.
6. Connect the power cable to the
connection block (see Power
connections, on page 9)
7. Slide the decoration ring on to the
AXIS 233D and lock into place by
tightening two M3 screws into the
bracket. Take care to place the side
with the open slot over the
connection blocks for cables.(Fig. E)
8. The hardware installation is now
complete, proceed to Assign an IP
address, on page 10 to install the
AXIS 233D on your network.
All manuals and user guides at all-guides.com
Captive screw
AXIS 233D Installation Guide
E
Slide on decoration ring
F
Slot for cables