Publicité
Les langues disponibles
Les langues disponibles
1
Signs and Symbols
Warning
This symbol signals passages in the manual which must be observed at all times. Non-compliance can
cause injuries or material damage.
Warning Laser
This symbol appears in front of warning passages concerning the danger of laser beams.
Information
This symbol signals passages with useful information.
2
Safety information
It is essential that this manual is read, thoroughly understood and observed before setting the
FT 50 RLA sensor into operation.
The FT 50 RLA sensor may only be connected, mounted and adjusted by qualified personnel.
Interventions and alterations to the device are not permissible!
The FT 50 RLA sensor is not a safety component as described by EU machine directives.
The FT 50 RLA sensor complies with laser protection class 2 according to DIN EN 60825/1, sta-
tus 2001. The technical requirements comply with EN 60947-5-2, 2000 edition.
Never look into the path of the laser. Do not suppress the reflex to close the eyelids.
Gazing into the beam path for longer periods can damage the retina of the eye.
When mounting the sensor, ensure if possible that the beam path is sealed off at the end.
The laser must not be directed at people (head height).
When aligning FT50 RLA, ensure that there are no reflections on reflective surfaces.
Should the safety label on the FT 50 RLA sensor be partly covered due to its installation positi-
on, other safety labels are to be positioned on visible parts of the sensor. When applying the new
safety label, make sure that you cannot look into the laser beam whilst reading it.
10
FT 50 RLA Distance sensor - Document 068-13799 - Status: 20.09.2005-00
Mounting and
operating instructions
Publicité
