WARNING : This operation must be perfomed
by a qualified technician
EN
INSTALLATION
INSTALLATION
INSTALLATION
INSTALLATION
INSTALLATION
Before operating your new appliance please read
this instruction booklet carefully. It contains
important information concerning the safe installation
and operation of the appliance.
Please keep these operating instructions for future
reference. Make sure that the instructions are kept
with the appliance if it is sold, given away or moved.
The appliance must be installed by a qualified
professional according to the instructions provided.
Any necessary adjustment or maintenance must be
performed after the appliance has been
disconnected from the electricity supply.
The following instructions should be read by a
The following instructions should be read by a
qualified technician to ensure that the appliance is
qualified technician to ensure that the appliance is
installed, regulated and technically serviced
installed, regulated and technically serviced
correctly in compliance with current regulations.
correctly in compliance with current regulations.
Positioning and levelling
It is possible to install the appliance alongside
cupboards whose height does not exceed that of the
hob surface.
This cooker should be installed directly on
. Do not install this cooker on an
. Do not install this cooker on an
. Do not install this cooker on an
. Do not install this cooker on an
. Do not install this cooker on an
the floor
artificial base of any kind.
artificial base of any kind.
artificial base of any kind.
artificial base of any kind.
Make sure that the wall in contact with the back of
the appliance is made from a non-flammable, heat-
resistant material (T 90°C).
Important: Do not install this appliance
Important: Do not install this appliance
Important: Do not install this appliance
Important: Do not install this appliance
Important: Do not install this appliance
Important: Do not install this appliance
Important: Do not install this appliance
Important: Do not install this appliance
adjacent to the door or other means of
adjacent to the door or other means of
adjacent to the door or other means of
adjacent to the door or other means of
adjacent to the door or other means of
adjacent to the door or other means of
adjacent to the door or other means of
adjacent to the door or other means of
access to minimise the likelihood of persons
access to minimise the likelihood of persons
access to minimise the likelihood of persons
access to minimise the likelihood of persons
access to minimise the likelihood of persons
access to minimise the likelihood of persons
access to minimise the likelihood of persons
access to minimise the likelihood of persons
using the door making contact with pans on
using the door making contact with pans on
using the door making contact with pans on
using the door making contact with pans on
the hob surface.
the hob surface.
the hob surface.
the hob surface.
the hob surface.
the hob surface.
the hob surface.
the hob surface.
The appliance must not be installed behind
a decorative door in order to avoid overheating
This appliance must not be fitted on a platform.
The cooker is designed to fit between kitchen cabinets
spaced 600mm apart. The space either side need
only be sufficient to allow withdrawal of the cooker for
servicing. It can be used with cabinets one side or
both as well as in a corner setting. It can also be used
free-standing.
Adjacent side walls which project above hob level,
must not be nearer to the cooker than 150mm or 65mm
and should be protected by heat resistant
material. Any overhanging surface or cooker hood
should not be nearer than 750mm.
a. The cooker may be located in a kitchen, a kitchen/
diner or bed sitting room, but not in a bathroom or
shower room.
b. The hoods must be installed according to the
requirements in the hood handbook.
c. The wall in contact with the back of the cooker must
be of flameproof material.
d. The cooker is fitted with a safety chain that must be
attached to a hook, secured to the wall behind the
appliance.
Before moving your cooker check that it is cool, and switched
off at the cooker control unit. Movement of your cooker is most
easily achieved by lifting the front as follows:
Moving the Cooker
Moving the Cooker
Fig. A
Fig. A
Open the grill door sufficiently to allow a comfortable
Open the grill door sufficiently to allow a comfortable
grip on the underside front edge of the oven roof,
grip on the underside front edge of the oven roof,
avoiding any grill elements. (FIG.A)
avoiding any grill elements. (FIG.A)
Take care in moving the cooker as it is heavy. Take care
to ensure that any floor covering is not damaged.
Electrical connection
Power supply voltage and frequency: 230-240V a.c.
50/60 Hz.
The supply cable must be positioned so that it never
reaches at any point a temperature 50°C higher than
the room temperature. The cable must be routed away
from the rear vents. Should you require it, you may
use a longer cable, however, you must ensure that the
cable supplied with the appliance is replaced by one
of the same specifications in accordance with current
standards and legislation.
WARNINGS: THIS APPLIANCE MUST BE
WARNINGS: THIS APPLIANCE MUST BE
WARNINGS: THIS APPLIANCE MUST BE
WARNINGS: THIS APPLIANCE MUST BE
WARNINGS: THIS APPLIANCE MUST BE
EARTHED.
EARTHED.
EARTHED.
EARTHED.
EARTHED.
The cooker must be connected to the mains by a
switched (double pole) cooker outlet correctly fused
with a capacity appropriate to that shown on the
cooker Rating Plate. All electrical wiring from the
consumer unit to the cooker, via the switched double
pole cooker outlet, must be of an acceptable type
and current rating as above.
8