Publicité
Les langues disponibles
Les langues disponibles
Advanced Operations
2. Follow the voice prompt and
press the remote pendant's
button once.
3. Wait for the 2nd voice prompt
to say, "Press and hold the
button until the phone beeps."
When you hear this, press and
hold the remote pendant's
button for about 4 seconds.
4. The low battery indicator will
blink rapidly and the phone will
beep at the end, indicating that
the remote pendant has been
programmed correctly. After the
phone beeps, the pendant
should be successfully
re-programmed. The ER unit will
then start the TEST mode. Go to
the previous section to test the
re-programmed pendant.
20
All manuals and user guides at all-guides.com
To Set the Inactivity Timer
• The Inactivity Timer activates the
Emergency Calling feature of the
ER. If, after either 24 or 48
hours, there hasn't been any
telephone activity on the ER, it
automatically begins dialing your
pre-programmed emergency
contacts.
• Your ER comes from the factory
with the Inactivity Timer set to
OFF. To turn it on and set it,
follow these steps:
1. With the handset in the cradle,
press the PROG button.
Publicité
