Bebeconfort EvolveFix i-Size Mode D'emploi page 33

• In 76-105cm, facing forwards, ensure every time you
change the tilt that the child seat is firmly attached to the
seat of the car (no slackness). If necessary, re-tighten the
isofix anchorage points.
• Make sure the fold-down rear seat is locked into position.
• Make sure that any luggage and other objects liable to
cause injuries in the event of a collision shall be properly
secure.
• Make sure the straps holding the carseat to the
vehicle are tight.
WARNING:
Warning : When the car seat is installed on the front passen-
ger seat, you must switch off the front passenger airbag if
your child is sitting in a rearward facing position.
Baby in the EvolveFix i-Size car seat :
• Never leave your child unattended.
• For your own safety and the one of your child always put
the child in the car seat and fasten him however short
your journey may be.
• Use the EvolveFix i-Size only on a front-facing seat that
is fitted with an automatic or static 3-point belt that has
been approved according to the ECE R16 standard or
similar. Do NOT use a 2-point belt.
• After putting the child in the car seat, ensure that the har-
ness is sufficiently tight by pulling the belt. Before every
use, make sure the harness is not damaged or twisted.
• Make sure you can fit no more than one finger between
the harnesses and your child (1cm). If there is more space
than 1 cm, tighten the harness belt further.
• Check to make sure the headrest is adjusted to the proper
height.
• Ensure that the straps under the stomach lie as low as
possible, to properly support the pelvis.
• Do not use the child restraint device without the cover.
Do not replace the seat cover with any other than the one
recommended by the manufacturer, because it will have a
direct effect on the functioning of the car seat.
• The temperature inside a vehicle may become very high,
particularly after a long period of exposure to the sun. It is
strongly recommended, under such conditions, to cover
the seat of the car with a piece of material or something
equivalent to prevent the harness fixings, and in particular
the metal parts, from becoming hot and burning the
child.
ATTENTION:
In ISOFIX use the fitting clips for lower anchorage to the
vehicle are not sufficient.
The ISOFIX anchors have been developed to obtain a safe
and easy fixation of the child safety systems inside the car.
Not all cars are equipped with these anchors although they
are standard on more recent models. Consult the list of
cars for which the car seat can be installed correctly on the
website www.bebeconfort.com.
• In forward facing position, the seat must be placed on the
car rear seat or exceptionally on the front seat in accor-
dance with the legislation in force in the country of use
(In France: in accordance with the conditions stipulated in
decree n° 91-1321 du 27-12-1991).
• Warning: when installing the car seat, spaces between
the base of the car seat and the vehicle seat are possible
depending on the position of the anchorage points
within the vehicle.
• The rigid parts and the plastic sections of a child restraint
device should be positioned and installed in such a way
that they cannot, when the vehicle is being used under
normal conditions, become trapped under a moving seat
33 33
EN