MINN KOTA CORDED FOOT PEDAL Manuel Du Propriétaire page 8

STOWING AND DEPLOYING THE MOTOR WITH THE FOOT PEDAL
FOOT PEDAL ADJUSTMENTS
STOWING AND DEPLOYING THE MOTOR WITH THE FOOT PEDAL
Use the following procedure to stow and deploy the motor. Keep in mind that if your motor is stalling at a 45-degree
angle when attempting to stow, this indicates that batteries are too low to fully stow the motor. If this occurs,
reengage power, deploy the motor, trim the motor to its highest setting, and turn power off until batteries can be
recharged. Once batteries are charged, attempt to stow motor again.
1
a. Locate the Indicator Panel at the base of
the Mount.
b. Make sure that the motor is on by checking that the
green LED next to the System Ready Indicator is on.
2
c. On the Foot Pedal, press the Mode Button until the
amber LED in the center of the Indicator Panel on
the Foot Pedal is illuminated. This puts the Foot
Pedal in Ulterra Mode.
NOTICE:
You can only stow and deploy your motor
while in Ulterra mode.
d. To deploy the motor, when it is stowed, double press
the Stow/Deploy button. To stow the motor, when it is
deployed, press the Stow/Deploy button.
WARNING
When stowing or deploying the motor, keep fingers clear of
all hinges, pivot points and all moving parts. When stowing
and deploying the motor, ensure that it doesn't contact the
boat, trailer, or any other obstruction.
8 | minnkotamotors.com
AUTOPILOT
SPOT-LOCK
Indicator Indicator
d.
Panel Panel
NOTICE:
The deploy sequence can be stopped at any time
pressing the stow/deploy button. The stow sequence can be
stopped at any time by pressing either trim button or the
stow/deploy button.
Power Button Power Button
System Ready System Ready
Indicator Indicator
AUTOPILOT
SPOT-LOCK
MODE
CONSTANT
Stow/Deploy Stow/Deploy
©2021 Johnson Outdoors Marine Electronics, Inc.
MODE MODE