MINN KOTA CORDED FOOT PEDAL Manuel Du Propriétaire page 4

INSTALLATION
INSTALLATION
Installing the Ulterra and Riptide Ulterra Foot Pedal
1
ITEM(S) NEEDED
#2 x 5
a. Take the Foot Pedal (Item #A) and turn it over.
Put a Foot Pedal Pad (Item #2) in each of the
pad locations.
NOTICE:
Adding the Foot Pedal pads is optional.
The pads are recommended when using the Foot
Pedal on non-carpeted surfaces.
2
b. Locate the Foot Pedal Cord that exits the mount of
the Ulterra or Riptide Ulterra, next to the Power Cord.
c. Unscrew the caps at the end of the Foot Pedal
cords exiting the motor and the Foot Pedal.
d. Plug the cords together and make sure the
connection is secure. Be sure to tighten the
connector retaining nut.
NOTICE:
The connectors are keyed to prevent
reversed installation.
4 | minnkotamotors.com
#A x 1
Foot Pedal Foot Pedal
Bottom Bottom
Foot Pedal Foot Pedal
Pad Placement Pad Placement
2b
Mount Mount
Foot Pedal Foot Pedal
Cord from Cord from
Trolling Trolling
Motor Motor
Power Power
Cord Cord
2d
Foot Pedal Foot Pedal
Cord from Cord from
Foot Pedal Foot Pedal
2c
Cap Cap
Foot Pedal Foot Pedal
Cord from Cord from
Foot Pedal Foot Pedal
Foot Pedal Foot Pedal
Foot Pedal Foot Pedal
Cord from Cord from
Trolling Trolling
Motor Motor
©2021 Johnson Outdoors Marine Electronics, Inc.