MINN KOTA CORDED FOOT PEDAL Manuel Du Propriétaire page 6

FOOT PEDAL OPERATION
You are responsible for the safe and prudent operation of your vessel. We have designed Ulterra to be an accurate and reliable tool that
will enhance boat operation and improve your ability to catch fish. This product does not relieve you from the responsibility for safe
operation of your boat. You must avoid hazards to navigation and always maintain a permanent watch so you can respond to situations
as they develop. You must always be prepared to regain manual control of your boat. Learn to operate your Ulterra in an area free from
hazards and obstacles.
Spot-Lock
The Spot-Lock button is located on the bottom, right side of the Foot Pedal and is labeled with an anchor symbol. When the Spot-Lock
button is pressed, the location of the motor is recorded to a temporary Spot-Lock location. The blue light
on the Indicator Panel is illuminated when Spot-Lock is engaged. To engage Spot-Lock press the Spot-Lock button, to disengage, press
the Spot-Lock button again. When engaging Spot-Lock, a tone will be emitted. When disengaging Spot-Lock with the Spot-Lock button,
no tone will be emitted. Steering the motor with the Foot Pedal or adjusting the speed using the Speed Knob will cancel Spot-Lock and
a High-Low, High-Low, High-Low tone will be emitted. Spot-Lock can be engaged in Normal and Ulterra Modes. Spot-Lock can also be
controlled with the remote. Spot-Lock can also be controlled with the remote. For more specific directions on how to use Spot-Lock,
please refer to your remote manual.
Steer Right/Steer Left
The Steer Right and Steer Left
the bottom of the Foot Pedal. They function to steer right and
left when the Foot Pedal is operating in Normal Mode. The
amber light on the Indicator Panel will not be illuminated
MODE
when in Normal Mode. Holding the Steer Right or Steer Left
buttons down will continue to steer the motor to the left or right. Small steering changes of less than one degree can be made by quickly
tapping the Steer Right and Steer Left buttons.
Trim Down/Trim Up
The Trim Down and Trim Up
bottom of the Foot Pedal. The Trim Down button trims the
motor down and the Trim Up button trims the motor up. Their
function is to trim the motor when the Foot Pedal is operating
in Ulterra Mode. The amber light
be illuminated during Ulterra Mode.
Prop ON/OFF
The Prop ON/OFF button is located in the middle, at the bottom of the Foot Pedal. It functions to turn the Prop on and off when the
Foot Pedal is operating in Normal Mode. The amber light
Prop will turn on when pressure is applied and turn off
when pressure to the button is removed.
Stow/Deploy
The Stow/Deploy button is located in the middle, at the
bottom of the Foot Pedal. It functions to stow and deploy
the motor when the Foot Pedal is operating in Ulterra Mode.
The amber light on the Indicator Panel will be illuminated
MODE
6 | minnkotamotors.com
WARNING
buttons are located at
buttons are located at the
on the Indicator Panel will
MODE
on the Indicator Panel will not be illuminated when in Normal Mode. The
MODE
CAUTION
The steering system is designed to turn your motor 360
degrees. Be careful to avoid over-wrapping the Coil Cord around
the trolling motor Shaft.
WARNING
When trimming the motor, keep fingers clear of all hinges, pivot
points and all moving parts. When stowing and deploying the
motor, ensure that it doesn't contact the boat, trailer, or any
other obstruction.
WARNING
When stowing or deploying the motor, keep fingers clear of all
hinges, pivot points and all moving parts. When stowing and
deploying the motor, ensure that it doesn't contact the boat,
trailer, or any other obstruction.
next to the Spot-Lock label
AUTOPILOT
SPOT-LOCK
©2021 Johnson Outdoors Marine Electronics, Inc.