Publicité
• Avoid contact with other electronic devices to avoid generating static discharges.
Note Immediately after installation, the displayed state of charge may be incorrect. After the first use of
the battery this will be corrected automatically by the battery monitor.
Switching the display on and off
The display automatically switches on when connected.
Note When not in use for a longer period of time or when no current is flowing, the display automatically
switches to standby mode. Tap on the display to reactivate.
Tap on the display to switch the display on.
Tap the off button to switch the display off.
Using general setting buttons
<
Tap the
button to display the previous screen.
>
Tap the
button to display the following screen.
+
Tap the
button to increase a value.
–
Tap the
button to decrease a value.
Calibrating the battery monitor
After connection, the battery monitor must be calibrated.
Note If other devices are connected to one of the batteries, the state of charge value may be displayed
incorrectly.
Fully charge the batteries.
The battery monitor is calibrated.
Making basic settings
Aer connection, the battery capacity of the connected battery and the time must be set before the battery monitor
can be used. The settings can be adjusted while using the battery monitor.
1.
Select the
button to open the battery settings menu.
2. Adjust the battery capacity of the connected battery.
>
3. Select the
button to open the time settings menu.
The upper value shows the hours. The lower value shows the minutes.
4. Adjust the time.
>
5. Select the
button to return to the home screen.
EN
17
Publicité
