DeWalt DCS373 Traduction De La Notice D'instructions Originale page 46

EnGLIsh
OPERATION
Instructions for Use

WARNING:
• Always observe the safety instructions and
applicable regulations.
• Ensure the material to be sawn is secured in place.
• Apply only a gentle pressure to the tool and do not
exert side pressure on the saw blade. If possible, work
with the saw shoe pressed against the workpiece. This
prevents damage to the blade and stops the tool from
jerking and vibrating.
• Avoid overloading.
• Let the blade run freely for a few seconds before
starting the cut.

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect battery pack
before making any adjustments or removing/
installing attachments or accessories. An accidental
start-up can cause injury.
Proper Hand Position (Fig. J)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the main handle
with the other hand on the auxiliary handle
Figure J, to guide the saw properly.
MAINTENANCE
Your D WALT power tool has been designed to
e
operate over a long period of time with a minimum of
maintenance. Continuous satisfactory operation depends upon
proper tool care and regular cleaning.

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect battery pack
before making any adjustments or removing/
installing attachments or accessories. An accidental
start-up can cause injury.
The charger and battery pack are not serviceable.
Replacing Sight Window (Fig. A)

WARNING: Do not operate the saw with a damaged or
missing sight window. If window is damaged or missing,
have the saw serviced at an authorised service centre. If
the saw is operated without the window, metal chips
could fly through the guard and cause personal injury.
The sight window 10 must be replaced by an authorised
D WALT service centre.
e

CAUTION: Do not use any cleaning fluids on the
sight window to avoid clouding it and compromising
the safe operation of the saw. Use compressed air to
remove accumulated dust from the inside of the sight
window. Wear safety glasses when performing this.
44
Lubrication
Your power tool requires no additional lubrication.
Cleaning


Optional Accessories

Use only 140 mm D
20 mm arbor.
Consult your dealer for further information on the
14 ,
appropriate accessories.
15 , as shown in
Protecting the Environment
be recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.
Rechargeable Battery Pack
This long life battery pack must be recharged when it fails
to produce sufficient power on jobs which were easily done
before. At the end of its technical life, discard it with due care for
our environment:
• Run the battery pack down completely, then remove it from
the tool.
• Li-Ion cells are recyclable. Take them to your dealer or a
local recycling station. The collected battery packs will be
recycled or disposed of properly.
WARNING: Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and around
the air vents. Wear approved eye protection and approved
dust mask when performing this procedure.
WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these
parts. Use a cloth dampened only with water and mild
soap. Never let any liquid get inside the tool; never
immerse any part of the tool into a liquid.
WARNING: Since accessories, other than those offered
by D WALT, have not been tested with this product, use
e
of such accessories with this tool could be hazardous. To
reduce the risk of injury, only D
e
accessories should be used with this product.
WALT metal-cutting blades with a
e
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can
WALT recommended