Panasonic EY7542 Instructions D'utilisation page 8

Reverse Rotation Switch
Operation
1. Push the lever for reverse rotation.
Check the direction of rotation be-
fore use.
. Depress the trigger switch slightly to
start the tool slowly.
3. After use, set the lever to its center
position (switch lock).
Selecting Mode
Select mode Intended use Work material
Fastening
Impact driver
Driving
Drill driver
mode with
clutch func-
Drilling
tion
WARNING!
This tool must not be used as a drill in
"Impact Driver mode". During drilling in
steel, the drill bit may break in case of
blocking and this may cause dangerous
cut wounds.
Impact Driver Operation
Select Impact Driver with the impact/
drill driver switch.
• Switch to the impact/drill driver posi-
tion only when the tool has completely
stopped rotating. Damage may be
caused if the tool is rotating.
The impact driver ( mark) display will turn
Drill Driver Operation
Select Drill Driver with the impact/drill
driver switch.
• Switch to the impact/drill driver posi-
The drill driver ( mark) display will turn silver.
Bolt
Nut
Wood screw
Clutch Torque Setting
Metal screw
Self-driving
screw
Wood
Metal
How to Use the Belt Hook
• Be sure to attach the belt hook
silver.
• Periodically check screw for tight-
• Be sure to attach the belt hook firmly
- 8 -
tion only when the tool has completely
stopped rotating. Damage may be
caused if the tool is rotating.
Adjust the torque to one of the 1
clutch settings or " " position.
CAUTION
:
Test the setting before actual opera-
tion.
Set the scale at this mark (
WARNING!
securely to the main unit with the
screw firmly fastened. When the belt
hook is not firmly attached to the main
unit, the hook may disconnect and the
main unit may fall.
This may result in an accident or
injury.
ness. If found to be loose, tighten
firmly.
and securely onto a waist belt or other
belt. Pay attention that the unit does not
slip off the belt. This may result in an
accident or injury.
).