MINN KOTA MKA-58 Instructions D'installation page 9

Les langues disponibles

For Terrova QUEST and Riptide Terrova QUEST

motors: reassemble the Springs that were

disconnected. Use a Needle-nose Pliers to grab the

hooked end of the loose Spring. Reconnect it by

pulling it upwards and hooking it in the hole on the

Side Rail. The curved end of the Spring should be

reattached from the top down. Make sure the

Spring is not twisted when reattaching it. Reattach

the Spring on both the right and left side of the

Base Extrusion.

CAUTION

When maneuvering each Spring, carefully handle the Spring

to avoid bending it. Do not grab the body of the Spring to

avoid pinching between the spring coils. Always grab by the

hooked end.

With the motor secured to the Reinforcement Plate,

the Sideplates can be reattached.

Replace the Right Sideplate and Left Sideplate.

Replace the four Sideplate Screws using a #3 Phillips

Screwdriver. Two of these screws will be located on

each side of the mount.

9 | minnkota.johnsonoutdoors.com

Needle-Nose Pliers

Hole in Side Rail

CAUTION

When handling each Spring, always keep the spring tension

under control. Abruptly releasing the Spring while there is still

tension could damage it and cause it to release unpredictably.

Spring

Sideplate

Screw

1854058