Publicité
Les langues disponibles
Les langues disponibles
3
ITEM(S) NEEDED
Images are a graphical representation only and
NOTICE:
may vary from your mounting position.
To prevent seizing of the stainless steel
NOTICE:
hardware, do not use high-speed installation tools.
f.
Use six 3/8-16 x 1¾ Screws (Item #10) to secure
the Inner Plate Assembly to the Reinforcement
Plate. The Screws should insert from the top down,
through the Stiffener Plate and Inner Plate that
make up the Inner Plate Assembly, and then into
the Reinforcement Plate. Tighten with a #4 Phillips
Screwdriver. Make sure all hardware is secure.
4
g.
Place the Outer Plate and motor onto the Inner
Plate that was mounted to the Reinforcement Plate.
Insert the Handle Assembly to secure the Quick
Release Bracket.
h.
Insert the Hair Clip Pin (Part #2260800) into the
Padlock Pin to complete the assembly. The straight
prong of the Hair Clip should pass through the center
of the Padlock Pin, with the curved prong wrapped
around the outside of the Padlock Pin. The Padlock
Pin should sit in the middle arch of the Hair Clip Pin.
CAUTION
Before using or transporting the trolling motor, always make
sure that the Handle Assembly is fully inserted and retained
by the Hair Clip Pin. Failure to insert and secure the Handle
Assembly may result in injury from a falling motor.
A padlock can be
NOTICE:
used in place of the Hair
Clip Pin to prevent motor
theft. The diameter of the
Padlock Pin is 1/4".
For warranty information, please visit minnkota.johnsonoutdoors.com.
minnkota.johnsonoutdoors.com
Part #2377183
#10 x 6
Minn Kota Consumer & Technical Service
Johnson Outdoors Marine Electronics, Inc.
PO Box 8129
Mankato, MN 56001
ECN 43074
Screw
Screw
Reinforcement
Reinforcement
Plate
Plate
Boat Deck
Boat Deck
4g
Inner
Inner
Plate
Plate
Reinforcement
Reinforcement
Plate
Plate
4h
Padlock Pin
Padlock Pin
121 Power Drive
Mankato, MN 56001
Phone (800) 227-6433
Fax (800) 527-4464
Outboard
Outboard
Inner Plate
Inner Plate
Assembly
Assembly
Outer Plate
Outer Plate
Padlock Pin
Padlock Pin
Handle
Handle
Assembly
Assembly
Hair Clip Pin
Hair Clip Pin
©2023 Johnson Outdoors Marine Electronics, Inc.
All rights reserved.
Rev B
Bow
Bow
05/23
Publicité
