Publicité
Les langues disponibles
Les langues disponibles
See side clearance
note below.
See side clearance
note below.
See side clearance
note below.
Min.
Clearance
Required
17
44.46 cm
Instructions For Installer:
S Save installation instructions for local inspector's use.
S Leave installation instructions with the appliance.
S Refer to "Installer Installation Suggestions" on page 3 before cutting.
S Dimensions shown in both inches and centimeters.
S Consult ducting guide for proper instruction.
S Dimensions "A" & "B" - tolerances +/-1/16² or +/-.16 cm.
S Dimension "J" - provide 2² min. (5.08 cm) cabinet clearance to motor for cooling purpose.
NOTE: Where possible, 6² (15.24 cm) is recommended for motor blower service.
S Dimension "K" - provide 6-1/4² (15.88 cm) required for removal of (supplied) grease container(s).
Installed dimension for (supplied) grease container(s) is 5-1/2² (13.97 cm).
S Side Clearance - grills installed near a side wall must allow a minimum clearance of 6² (15.24 cm) between cooktop
and sidewall for maximum performance. Minimum clearance of 1² (2.54 cm) is required to sidewalls and 3/4²
(1.905 cm) to rear wall.
S Electrical Hookup - the unit must be properly circuit protected and wired according to local electrical codes. See
electrical wiring information on page 3. Unit power requirements are located on the serial plate.
All manuals and user guides at all-guides.com
Min.
Clearance
Required
²
17
1/2
44.46 cm
Min.
Clearance
Required
11
7/16
²
17
1/2
29.06 cm
44.46 cm
²
11
7/16
29.06 cm
²
1/2
SINGLE
4
3/4
12.01 cm
Grease
Container
SEE NOTE
²
12
BELOW
1/2
31.76 cm
DOUBLE
12.01 cm
²
SEE NOTE
²
12
1/2
31.76 cm
TRIPLE
SEE NOTE
BELOW
²
30
1/8
76.52 cm
2
²
SEE NOTE
BELOW
²
4
3/4
SEE NOTE
BELOW
BELOW
²
4
3/4
12.01 cm
SEE NOTE
BELOW
Publicité
