Migatronic MK III Manuel D'instruction page 11

13 1
8
7
MIG 445
2
3
t
t2
9 11
1. Main switch
2. Central adaptor
For welding torch.
3. Quick release connector
For the torch cooling system.
4. Inductance output
Recommended wire diameter ø 0.6 – 1.0
5. Inductance output
Recommended wire diameter ø1.2 – 1.6
6. ON
Lights when the machine has been turned on.
7. Wire speed
This control knob is used to set the required
wire speed.
8. Trigger mode
This switch is used for setting of either 2-times
or 4-times trigger function, and spot welding.
All manuals and user guides at all-guides.com
CONTROL SWITCHES C-MODEL
6 15 14
5
4
t
61112585
10 12
11
9. Inching button (positioned above the wire
motor)
This button is used for fitting of the welding wire.
When the button is activated the wire is fed at
the speed på ca. 4 m/min.
10. Burn-back (positioned above the wire motor)
Adjustable delay between the wire feed unit
stops and the welding voltage is turned off in
order to prevent sticking of the wire.
11. Gas post-flow (positioned above the wire motor)
Gas post-flow time.
12. Soft-start (positioned above the wire motor)
Pre-setting of soft-start determines the speed at
which the wire will feed before the arc is ini-
tiated.
In position "OFF" the wire will start feeding at
the speed selected on the wire speed control
knob. (pos. 7).
13. Voltmeter / Ammeter (extra equipment)
Shows the welding voltage and the welding
current, and wire speed in metres per minute.
Kit no. 78861175.
14. Adjustment of welding voltage
MIG 385 (1 - 12) fine adjustment
MIG 445 (1 - 12) fine adjustment
15. Adjustment of welding voltage
MIG 385 (1 - 2) coarse adjustment
MIG 445 (1 - 2) coarse adjustment
Torch regulation
When using a torch with regulation in the handle the
wire speed can be adjusted from this.
This function is active when the wire speed potentio-
meter (pos. 7) is in the position min.