Operation And Use; Color Screen Wire Controller Interface Introduction; Color Screen Wire Controller Function Introduction - Norsup 7026965 Notice Originale

SWIMMING POOL HEAT PUMP TYPE PV
4.

OPERATION AND USE

4.1 COLOR SCREEN WIRE CONTROLLER
INTERFACE INTRODUCTION
(1) Main interface
1 9 2 3 4 5 6
(2) Button Description
NO. NAME NAME
1 ON/OFF Press to start /shut off the unit
2 Parameter Click this button to view the unit
state and the parameter
3 CLOCK Press to set the clock, the timer on
or timer off. When the timer was
starting, the button is green
4 Fault display Click to view fault history
5 Silent Click to turn on/off silent function
setting and to set timing Low
speed function
6
MODE Click to enter mode setting and the
target temp. Setting interface
7 Temp. curve Click to view the temp. and power
curve
8 Water Inlet Click to enter mode setting and the
Temp. target temp. Setting interface
9
LOCK Click to lock the screen. Input "22"
to unlock the screen by press the
"lock button"
16 WWW.NORSUP.EU
4.2 COLOR SCREEN WIRE CONTROLLER
FUNCTION INTRODUCTION
(1) Booting and shutdown
As shown in figure 1.1: In shutdown status, click 1
then the unit will be booted In booting status,
click 1 then the unit will be shut down.
7 (2) Mode switch and target temperature Setting
(2.1) Mode switch In the main interface, click mode
button or inlet water temperature setting button,
interface displays as follows:
8 2
3 4 1
Click the refrigeration mode button 1 , automatic
mode button 2 or heating mode button 3 then
you can select the corresponding mode.
(2.2) Target temp. setting
Click the temperature set button 4, you can set
the target temperature.
NOTE
When the unit is designed for single automatic mode
or single thermal mode, the mode can not be switched.
Alterations which serve the technological progress as well as errors excepted!
SWIMMING POOL HEAT PUMP TYPE PV
(3) Clock setting
In the main interface, click on the clock Settings
button, interface displays as follows:
1 2
(3.1) The operation of time setting
Click on the time Settings button 1, interface
displays as follows:
Click the value to set time directly, the click confirm
button to save the Settings. For example: setup
time: the 30-11-2016 16:00:00, input 30 11 16 16 00
00, the time change then click confirm button.
NOTE
If the input format is not correct, the wrong time
will be saved by clicking confirm button.
Alterations which serve the technological progress as well as errors excepted!
(3.2) The operation of timing setting
Click the timing set button 2 to enter
timing setinterface.
1 2 3 4
NO. NAME BUTTON NAME
COLOR
1 Timing - Start: Click this button to
table green start or end
- End: timing start setting
gray function
2 Timing on Click to set start time
setting of the timing
3 Timing - Open: Click this button to
end red start or end
button - End: timing end setting
gray function
4 Timing off Click to set end time
setting of the timing
ORIGINAL MANUAL NORSUP
EN DE
EN NL
DE
FR
DK
SE
17