Norsup 7026965 Notice Originale page 10

SWIMMING POOL HEAT PUMP TYPE PV
When the timer was starting, the clock button is
green in the main interface.
(4) Silent setting and silent timing setting
Click the silent setting button, and the interface
displays as follows:
1 2
(4.1) The silent button
Click the silent button 1, the unit will enter the silent
mode, and interface displays as follows:
Click the silent button 1 again, to exit the silent
mode.
18 WWW.NORSUP.EU
(4.2) Timing silent function setting
Click timing silent button 2, and interface displays as
follows:
1
2
3 4
NO. NAME COLOR NAME
1
Timing Used: red Click to use or unuse
silent off Unused: timing off function
gray
2 Timing Use: green Click to use or unuse
silent on Unused: timing on function
gray
3 Timing Click this button to set
silent start the timing silent start
time time
4
Timing Click this button to set
silent end the timing silent end
time time
Start time and end time setting value must be among
the range of 0:00 -23:00, and setting value can be
precise to hour digit.
For example above, click "ON" to use timing silent,
the unit will start the silent at 0:00 points and end at
4:00; click "OFF" to unuse the timing silent, but if the
unit is in timing silent mode, it will exit silent timing
immediately.
Alterations which serve the technological progress as well as errors excepted!
SWIMMING POOL HEAT PUMP TYPE PV
(5) History of the fault
In the main interface click fault display key,
interface displays as follows:
Fault time
day - month - year
Fault code The fault name
hour: min
If no failure, main interface displays static " "
When fault occurs, the fault icon will flash between
the " " " ", the failure interface will record time,
code, name of the fault.
After troubleshooting, if you do not check the
failure record, the main interface will display static "
"; if you check the failure record, the main
interface will displays static " ";
Failure record is in reverse order, according to the
happening time. Press the "Clean" key, you can
delete the fault record.
(6) Temperature curve
In the main interface, click the curve display button,
interface displays as follows:
(6.1) Temperature recording curve is as follows:
Alterations which serve the technological progress as well as errors excepted!
(6.2) The average power curve
Temperature curve automatically updates every one
hour, and the curve record can be stored for 60 days;
Start from the latest curve saved time, if power is off
and curve data collecting time is less than one hour,
the data in this period will not be saved;
ORIGINAL MANUAL NORSUP
EN DE
EN NL
DE
FR
DK
SE
19