Carrier Comfort Serie Manuel D'utilisation Et D'installation page 17

Installation
To Enter the Installer Configuration Mode
Press zone (
) and hold ( ) buttons simultaneously
for 3 seconds, the parameter number will be flashing on
the timing-zone and parameter value will be displayed in
temperature-zone of the display.
To modify parameters value, follow steps 3 to 8 of paragraph
"Changing user settings".
Installer configuration default reset
Press zone ( ) and hold (
seconds to enter into the installer configuration mode.
When this setting is first selected, 899 shall be displayed
in the temperature zone and an initial value of 10 shall be
displayed in the time-zone of the display. Press and hold
the down button. When the counter reaches zero, "Fd" shall
All manuals and user guides at all-guides.com
) buttons at a time for 10
Parameter number (ref table 1)
3 sec
be displayed in the temperature-zone of the display. This
represents factory defaults are in progress. Upon successful
completion of restoring defaults to EEPROM, the NUI shall
than force a reset.
17