Kicker KS Serie Manuel D'utilisation page 14

Tweeter Mounting
The tweeter can be separately mounted one of three
ways: flush, angled and pod. For flush mounting
applications, choose a flat location on the panel
with space behind the panel to allow room for the
short mounting nut, motor structure, and tweeter.
After checking the clearances, cut a 1-3/4" (44mm)
diameter mounting hole in the panel. Position the
short mounting nut behind the panel. Feed the wire
through the optional flush ring, the hole in the panel,
and the mounting nut. Mount the tweeter by screwing
the mounting nut onto the tweeter.
For angled mounting applications choose a flat
location on the panel with space behind the panel to
allow room for the long mounting nut, motor structure,
tweeter post, and back angle ring. After checking the
clearances, cut a 1-3/4" (44mm) diameter mounting
hole in the panel. Place the front angle ring in front of
the panel. Then place the wire and tweeter through
the front angle ring and into the panel. Next, place
the wire through the back angle ring, place the back
angle ring over the rear of the tweeter, and line-
up the narrow part of the front angle ring for the
preferred angle of operation. Place the wire through
the mounting nut and loosely tighten the mounting nut
around the tweeter. Rotate all the parts in unison until
the tweeter is angled in the desired direction. Secure
the assembly by tightening the mounting nut.
English 14