Kicker KS Serie Manuel D'utilisation page 10

Crossover Mounting
Mount the crossover in a location that is easy to
access for wiring and tweeter output level adjustment.
Make sure that the crossover will not be exposed
to water. The bottom of the car door is not a good
location. If you must mount the crossover in the car
door, exercise caution as water can accumulate in the
bottom of the door. Keep the crossover high in the
door and shielded from water.
tweeter mounting hole
to tweeter lead wires
woofer mounting hole
If factory speaker wiring is not available in your desired
location, it may be necessary to run speaker wire
through the door jamb. The speaker wire should be
kept away from sharp edges and avoid the possibility
of getting pinched by the door. An existing grommet
in the door jamb is the ideal place to run the speaker
wire. If the factory hole and grommet do not exist
or are inaccessible, you must drill a hole to run the
English
KS crossover. (mounted
inside door panel)
to woofer
terminals
rubber
grommets
door jamb
from
amplifier or
source unit
10