Nordpeis Box N-20A Manuel D'installation page 5

Nordpeis Box N-20A
Insert: N-20A
Steel chimney
Can be connected to steel chimney.
Weight including insert
Nordpeis Box N-20A
Accessory
Nordpeis Box N-20A module small
Nordpeis Box N-20A module large
If the stove is combined with one or more modules
beside the stove, make sure the floor beneath the
base of the stove is either level with or slightly
higher (up to 4mm) than the floor beneath the
modules. If this is not the case the stove must be
lifted by using shims and / or tile glue to achieve
the correct height. The modules can be adjusted
to match the height of the stove using the provided
set screws.
For more information see separate assembly
instructions for modules.
Floorplate
Please follow the rules and regulations regarding
floorplates in your country.
Safety Distances (FIG 2 - 2b)
Make sure that the safety distances indicated below are
followed.
Illustration (FIG 1 - 1c)
*The illustration indicates the approximate centre height
of the flue pipe. Consider possible inclination of
the flue prior to perforating the chimney . Distortions in
floors and walls may influence the height. Dry stack
the fireplace for accurate height and positioning of
the flue/chimney connection. If a fresh air supply set
(accessory) is connected through the floor, prepare the
bottom element before assembly.
Fresh air supply (accessory)
ATTENTION! The product can only be connected to
the fresh air supply through the pre cut areas in the
surround (See FIG 1b Nordpeis Box N-20A =AIR). Seal
off the gap between the fresh air hose and the concrete
with a non combustible sealant.
For more information see separate assembly
instructions for fresh air supply.
210 kg
28,5 kg
42 kg
GB
5