Télécharger Imprimer la page

ZANKER ZKI1415 Notice D'utilisation page 27

Publicité

Les langues disponibles

Les langues disponibles

Malfunction
The appliance does not drain the
water.
The anti-flood device is on.
The start of the washing pro-
gramme does not occur.
After the check, turn the programme knob on the same
washing programme before the malfunction occurred.
The programme continues from the point of interrup-
tion.
If the malfunction occurs again, contact the service cen-
tre.
If the different alarm codes show, contact the service
centre.
The washing results and drying results are not satisfactory
Problem
The dishes are not clean.
All manuals and user guides at all-guides.com
Possible cause
The water inlet hose is damaged.
There is a blockage in the sink spi-
got.
The connection of the water drain
hose is not correct.
The water drain hose is damaged.
The appliance door is open.
You did not press the start/cancel
button.
The mains plug is not connected in
the mains socket.
The fuse in the fuse box is dam-
aged.
Possible cause
The selected washing programme
was not applicable for the type of
load and soil.
The baskets were not loaded cor-
rectly, water did not touch all surfa-
ces.
The spray arms could not turn free-
ly because of incorrect arrange-
ment of the load.
Make sure that the water inlet hose
has no damages.
Clean the sink spigot.
Make sure that the connection is
correct.
Make sure that the water drain
hose has no damages.
Close the water tap and contact the
service centre.
Close the appliance door.
Press the start/cancel button.
Connect the mains plug.
Replace the fuse.
The necessary information for the service centre is on
the rating plate.
Record this information:
– Model (MOD.) ........................................................
– Product number (PNC) ..........................................
– Serial number (S.N.) ..............................................
Make sure that the washing pro-
gramme is applicable for the type of
load and soil.
Load the baskets correctly.
Make sure that an incorrect ar-
rangement of the load does not
cause a blockage of the spray
arms.
Possible solution
Possible solution
27

Publicité

loading