ZANKER ZKI1415 Notice D'utilisation page 17

• Do not remove the dishes from the appliance until
the washing programme is completed.
Care and cleaning
• Before you clean the appliance, deactivate it and dis-
connect the mains plug from the mains socket.
• Do not use flammable products or products that can
cause corrosion.
• Do not use the appliance without the filters. Make
sure that the installation of the filters is correct. An
incorrect installation causes unsatisfactory washing
results and damage to the appliance.
• Do not use spray water or steam to clean the appli-
ance. Risk of electrical shock and damage to the ap-
pliance.
Installation
• Make sure that the appliance is not damaged. Do not
install or connect a damaged appliance, contact the
supplier.
• Remove all packaging before you install and use the
appliance.
• Only a qualified person must do the electrical con-
nection, the plumbing and the installation of the ap-
pliance. This to prevent the risks of structural dam-
age or injury.
• Make sure that the mains plug is disconnected from
the mains socket during installation.
• Do not drill into the sides of the appliance to prevent
damage to hydraulic components and electrical com-
ponents.
• Important!Obey the instructions in the template sup-
plied with the appliance:
– To install the appliance.
– To assemble the door panel.
– To connect to the water supply and drain.
• Make sure that the appliance is installed below and
adjacent to safe structures.
Frost precautions
• Do not install the appliance where the temperature is
less than 0 °C.
• The manufacturer is not responsible for frost dam-
age.
Water connection
• Use new hoses to connect the appliance to the water
supply. Do not use used hoses.
All manuals and user guides at all-guides.com
• Do not connect the appliance to new pipes or pipes
not used for a long time. Let the water flow for some
minutes, then connect the inlet hose.
• Make sure not to squash or cause damage to the
water hoses when you install the appliance.
• Make sure that the water couplings are tight to pre-
vent a water leakage.
• The first time you use the appliance, make sure that
the hoses do not have water leaks.
• The water inlet hose has a safety valve and a double
sheath with an inner mains cable. There is pressure
in the water inlet hose only when the water flows. If
there is a leak in the water inlet hose, the safety
valve interrupts the flow of water.
– Be careful when you connect the water inlet hose:
– Do not put the water inlet hose or the safety
valve in water.
– If the water inlet hose or the safety valve are
damaged, immediately disconnect the mains
plug from the mains socket.
– Contact the service centre to replace the water
inlet hose with safety valve.
Warning! Dangerous voltage.
Electrical connection
• The appliance must be earthed.
• Make sure that the electrical information on the rat-
ing plate agrees with the power supply.
• Always use a correctly installed shockproof socket.
• Do not use multiple plugs and extension cables.
There is a risk of fire.
• Do not replace or change the mains cable. Contact
the service centre.
• Make sure not to squash or cause damage to the
mains plug and cable behind the appliance.
17