5
Put the flat filter A in the
bottom of the appliance.
Install the flat filter cor-
rectly under the two
guides D.
What to do if...
The start of the appliance does not occur or it stops
during operation.
First try to find a solution to the problem (refer to the
table). If not, contact the service centre.
• The start/cancel indicator flashes continuously.
• The end indicator flashes one time intermittently.
• The start/cancel indicator flashes continuously.
• The end indicator flashes two times intermittently.
• The start/cancel indicator flashes continuously.
• The end indicator flashes three times intermittently.
Warning! Deactivate the appliance before you do
the checks.
Malfunction
The appliance does not fill with wa-
ter.
26
All manuals and user guides at all-guides.com
6
Put the filter system in
position. To lock the filter
system, turn the handle
clockwise until it locks in
position.
Alarm code
Possible cause
The water tap is blocked or there is
limescale on it.
The water pressure is too low.
The water tap is closed.
The filter in the water inlet hose is
blocked.
The connection of the water inlet
hose is not correct.
To clean the spray arms
Do not remove the spray arms.
If the holes in the spray arms become clogged, remove
remaining parts of soil with a thin pointed object.
To clean the external surfaces
Clean the external surfaces of the appliance and con-
trol panel with a moist soft cloth.
Only use neutral detergents.
Do not use abrasive products, abrasive cleaning pads
or solvents (acetone).
With some malfunctions the indicators flash to
show an alarm code.
The appliance does not fill with water.
The appliance does not drain the water.
The anti-flood device is on.
Clean the water tap.
Contact your local water authority.
Open the water tap.
Clean the filter.
Make sure that the connection is
correct.
Malfunction
Possible solution