Publicité
Les langues disponibles
Les langues disponibles
WARNING
!
•
Risk of fi re!
•
Never obstruct the front opening of the appliance.
•
The front of the appliance must be fi nished with any non-combustible materials such as brick, marble, granite,
etc., provided that these materials do not go below the specifi ed dimension, as illustrated.
•
Do not strike, slam, or scratch. Do not operate appliance with glass removed, cracked, or scratched.
•
Facing and/or fi nishing material must never overhang into the appliance opening.
•
The glass door assembly is a safety device designed to pivot forward when relieving excess pressure that
might occur. Finishing or other materials must not be located in the opening surrounding the door as this will
interfere with the doors ability to relieve pressure.
•
If applicable, drywall dust will penetrate into the blower bearings, causing irreparable damage. Care must
be taken to prevent drywall dust from coming into contact with the blower or its compartment. Any damage
resulting from this condition is not covered by the warranty policy.
11.1
shipping bracket
Remove the door(s), refer to "door removal / installation " section for instructions.
A.
Cut the strap holding the glass and vent thimble in place.
B.
Remove the 2 screws holding the shipping bracket / vent shield in place, as shown.
C.
note:
The two screws removed from the shipping bracket vent shield MUST be replaced.
11.2
main safety barrier removal / installation
A barrier designed to reduce the risk of burns from the hot viewing glass is provided with the
appliance and shall be installed.
Before the glass door can be removed, the safety screen must be removed. Lift the safety screen up and pull it
out of the bottom retainer. Pull the safety screen down and out of the top retainer.
Reverse these steps to reinstall the safety screen. Ensure it is installed correctly.
finishing
11.0 finishing
45.1
W415-4020 / 08.09.21
EN
37
Publicité
