Vimar ELVOX TAB Serie Manuel Installateur page 12

Operation
Important: For the monitor to work, the ID must have already been pro-
grammed. To check this, press any of the monitor buttons. If an ID has
been assigned to the monitor, a beep will sound when a button is pressed;
if no ID has been assigned or it has been deleted, a triple beep will sound.
Operating times
The answer and conversation times depend on the configuration of the
corresponding entrance panel parameters (to change these times, please
refer to the electronic entrance panel unit instructions).
- Answer time (for entrance panel call): Default value 30 s
(minimum value 1 s, maximum value 255 s)
- Answer time (for intercommunicating call): 30 s (fixed value)
- Conversation time (for entrance panel call): Default value 120 s
(minimum value 10 s, maximum value 2550 s)
- Conversation time (for intercommunicating call): Default value 5 minutes
(can be modified to unlimited time).
Answering a call
A call from the outdoor entrance panel or from an intercommunicating de-
vice can be answered during the chime cycle or once it has ended. To
answer, lift the handset; to end the call, replace the handset.
Receiving a door call
The monitor can receive calls from a door call button if connected to termi-
nals M and FP directly or via interface 6120 (see wiring versions).
When the door call button is pressed, the monitor emits a different tone to
the one used for outdoor entrance panel calls or intercommunicating calls.
To stop the chime, lift the handset.
In the case of a door call by means of a button connected directly to the
monitor's terminals FP and M; chime cycle duration depends on how long
the button was held down (max. 10 s)
Making an intercommunicating call
To make a call to another indoor unit, one or more buttons must have been
programmed (see "Button programming" section).
To make the call, press the button programmed for the relevant indoor unit.
During the call, the monitor emits a tone in order to signal that the call is
being made. If the interphone/monitor is already engaged in another call,
a tone will be heard on the monitor making the call to indicate that the user
receiving the call is busy.
When the indoor unit receiving the call answers, communication begins
automatically. Replace the handset to end the conversation.
The maximum conversation time is 5 minutes (default).
Muting the ringtone during a call (Mute function)
When receiving a call from an outdoor entrance panel or from an intercom-
municating device or a door call via device 6120, the call ringtone can be
muted by pressing button B.
Door lock command
Press the lock button (with the handset hooked on or in conversation) to
send a lock opening command to the entrance panel (by default, the last
entrance panel to make a call).
Self-start
Self-start with dedicated button (button A):
-
to use the self-start function and communicate with the master entrance
panel, briefly press button A (self-start) to turn on the monitor and lift
the handset to start the conversation. Replace the handset to end the
conversation.
- Self-start with programmed button to a specific panel:
to use the self-start function and communicate with a specific entrance
panel, press and release the button programmed to call that entrance
panel (see "Programming the self-activation/self-start button to a specific
panel " section).
Calling a porter switchboard
To call a porter switchboard (if present in the system): lift the handset and
press button C (lock) to make the call.
12
All manuals and user guides at all-guides.com
Hearing aid function (art. 7529/D only)
Art. 7529/D has an internal coil which allows hearing aid wearers to use
the device. In this operating mode, the hearing aid must be switched to the
"T" position. However, for correct operation of the hearing aid refer to its
instruction manual.
Note: metal objects or electronic equipment in the vicinity may affect the
quality of the sound received by the hearing aid.
GB