Publicité
Les langues disponibles
Les langues disponibles
Overlay S eries
( 42" [106.7 cm] Models)
Features factory-installed,
overlay style trim, to provide a
"frameless"
look. This series requires the installation of custom
panels, handles, and standoffs.
KBFO42FTX
INSTALLATION
REQUIREMENTS
IMPORTANT:
•
Installer: Leave Installation Instructions with the homeowner.
•
Homeowner:
Keep Installation Instructions for future
reference. Save these Installation Instructions for the local
electrical inspector's use.
Tools Needed
Gather the required tools and parts before starting installation.
Read and follow the instructions
provided with any tools listed
here.
•
Cordless drill
•
•
Drill bits
•
•
Adjustable wrenches (2)m
•
Phillips screwdriver
•
•
Small level
•
•
Appliance dolly
•
Torx ®tT15 and T27 screwdrivers
1½2" nut driver
3/8", 1/4",and 1/2"open-end
wrenches
%2" hex key
1/4"and %e" socket drivers
Tape measure
•
Utility knife
Parts Needed
•
Six #8 x 3" (7.6 cm) wood screws (longer screws may be needed)
•
One or two 2" x 4" x 32" (5 cm x 10 cm x 81 cm) wood board(s)
•
Order factory panels, make custom panels or consult a
qualified cabinetmaker
or carpenter to make the panels.
Classic Series: Order factory panels, make custom panels, or
consult a qualified cabinetmaker
or carpenter to make the
panels. See "Installation
Requirements" for more information.
Overlay Series: Make custom panels, or consult a qualified
cabinetmaker
or carpenter to make the panels. See
"Installation
Requirements"
for more information.
Architect ®Series is shipped complete.
•
If you are connecting the water line directly to copper tubing
and not to a shutoff valve, you need a ferrule, a union, and a
1/4"compression
fitting.
The refrigerator can be recessed in an opening between cabinets
or installed at the end of a cabinet run using a side panel to
enclose the refrigerator.
Explosion
Hazard
Keep flammable
materials
and vapors,
such as
gasoline,
away from refrigerator.
Failure to do so can result in death, explosion,
or fire.
IM PORTANT:
•
Observe all governing codes and ordinances.
•
It is recommended
that you do not install the refrigerator near
an oven, radiator, or other heat source.
•
Do not install in a location where the temperature will fall
below 55°F (13°C).
•
Floor must support the refrigerator weight, more than 600 Ibs
(272 kg), door panels and contents of the refrigerator.
•
Ceiling height must allow for side tipping radius. See "Tipping
Radius."
•
Location should permit door to open fully. See "Door Swing
Dimensions."
•
Location must permit top grille removal. See "Opening
Dimensions."
Opening Dimensions
To avoid tipping during use, the solid soffit must be within 1"
(2.5 cm) maximum above the refrigerator. If the solid soffit is
higher than 1" (2.5 cm) or one is not available, then the
refrigerator must be braced.
If the anti-tip boards are needed, they must be attached to
the rear wall studs 80" to 90" (203 to 229 cm) above the floor.
See "Install Anti-Tip Boards" for more information.
NOTE: A clearance of 1/2"(1.3 cm) must be maintained in front
of the refrigerator's side trim in order for the top grille to be
removed.
t®TORX
is a registered trademark
of Saturn Fasteners, Inc.
Publicité
