Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions - Door Panel Adjustments and Trim Installation
Side to Side Adjustment
1. Loosen Phillips screws on back side of stainless steel
panel at each bracket location.
2. Adjust the panel(s) side to side.
3. Tighten screws.
Height and Depth Adjustment
1. Loosen the black screws at each bracket location
using the M5 Allen wrench.
2. Use the M4 Allen wrench to adjust the refrigerator
door panel depth and height to align with the adjacent
cabinetry. Do not over torque adjustment screws,
panel bracket tabs will bend and prevent proper
trim attachment. There must be a minimum 1/8" gap
between the panel and the adjacent cabinetry.
Depth Adjustment
Vertical
Adjustment
3. Once adjustments are complete, tighten black
screws.
Phillips
Screws
Black
Screw
Printed in the United States
Trim Installation
1.
Before installing trims, inspect bracket tabs to verify
they are not bent (see image). Tabs must be parallel
to the panel in order to properly install the trims.
X
2. Clip trim onto brackets to hide the panel adjustment
hardware.
3. Add trim caps to cover the ends of the trim.
Note: If trim caps are not flush with the top of the door,
hold the top and bottom caps when adjusting the trim
up or down so that the caps do not come loose. Make
sure the caps are flush to the trims after adjustment.
NOTE: While performing installations described in this book,
safety glasses or goggles should be worn.
NOTE: Product improvement is a continuing endeavor at
GE Appliances. Therefore, materials, appearance and
specifications are subject to change without notice.
60
31-1000731 Rev. 1
Publicité
