Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions - Single Standard Installation
STEP 9 FINAL EXTERNAL UNIT
PREPARATION (Cont.)
If installation requires a
limiter pin(s) must be installed
BEFORE the unit is removed from the shipping skid.
Pin is located in the hardware kit.
- Open the door to expose the hole in the back hinge
bracket and install the limiting pin. Pin must be
fully seated in the hinge or the door will not close
properly.
STEP 10 HANDLE INSTALLATION
Make sure the set screws in the handle caps are
loosened. Place the handle over the fasteners on
the door (we recommend putting the screw side of
the handle toward the less visible side). Take care to
support the handle so it doesn't fall and scratch the
appliance finish. Make sure both of the handle caps
are resting on the face of the door.
Fastener
Lock one end of the handle into position by tightening
the set screw in the handle cap with the 1/8" Allen
wrench. Be sure not to over tighten.
Keep supporting the handle as you lock the other
end of the handle into position by tightening the set
screw in the handle cap with the 1/8" Allen wrench.
Be sure not to over tighten.
Repeat these instructions on all other handles.
90°
door opening, the hinge
in the top hinge(s)
Set Screw
STEP 11 TOE KICK INSTALLATION
Use the stainless steel toe kick provided with the
Single Standard Installation Kit ZKW36V.
Remove the toe kick magnet from the front access
cover.
Adhere magnet to the back side of the toe kick. The
surface of the toe kick where the magnet is to be
placed must be clean and free of foreign material.
Center magnet vertically and horizontally.
Position toe kick on bottom portion of front access
cover.
STEP 12 INTERNAL UNIT
PREPARATION
Remove all tape, cardboard, and foam from each
unit.
Remove boxed door bins from shelves.
Unbox and install door bins.
16
31-1000731 Rev. 1
Publicité
