Publicité
Les langues disponibles
Les langues disponibles
Design Guide - Single Integrated Installation
SINGLE INTEGRATED INSTALLATION SPACE
Dimensions in parentheses are in centimeters.
84" (213.4)
Product Clearances
These units are equipped with a 2-position door stop.
The factory set 115° door swing can be adjusted to 90° if
clearance to adjacent cabinets or walls is restricted.
Refer to Dim A on page 6 for clearances needed for door
swing.
Water And Electrical Locations
Electrical and water supply must be located as shown.
The Cutout Depth Must Be 25".
31-1000731 Rev. 1
36" (91.4)
9"
18"
(22.9)
(45.7)
8"
9"
(20.3)
(22.9)
ELECTRIC
WATER
6" (15.2)
6" (15.2)
Finished
Return on both
sides and top
* For installation spaces deeper than 25", it is
2 1/2" (6.4)
recommended to install a spacer block per the
Additional Specifications
A 115 volt 60Hz., 15 or 20 amp power supply is
required. An individual properly grounded branch circuit
or circuit breaker is recommended. Install a properly
grounded 3-prong electrical receptacle recessed into
the back wall. Electrical must be located on rear wall
as shown.
The water line should be 1/4" O.D. copper tubing or
QuickConnect™ kit (WX08X10006) between the cold
water line and water connection location, long enough
to extend to the front of the unit (8' [2.4 m]). Installation
of an easily accessible shut-off valve in the water line
is required.
matching cabinet exterior is recommended on
interior on all sides and top at front of opening.
19
25" (63.5)
24 7/8"
(63.2)*
80"
(203.2)*
dimensions shown.
Publicité
