Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions - Single Integrated Installation
STEP 2 INSTALL WATER LINE
WARNING
Connect to potable water supply
only. A cold water supply is required for automatic
icemaker operation. The water pressure must be
between 40 and 120 psi (275-827 kilopascals).
AVERTISSEMENT
alimentation d'eau potable seulement. Une alimentation
d'eau froide est requise pour faire fonctionner
la machine à glaçons et le pichet à remplissage
automatique.
La pression d'eau doit se situer entre 40
et 120 psi. (275 à 827 kPa).
ADVERTENCIA
suministro de agua potable únicamente. Se requiere
un suministro de agua fría para el funcionamiento de
la jarra automática. La presión del agua deberá estar
entre 40 y 120 p.s.i. (275 – 827 kPa).
WARNING
ELECTRIC SHOCK HAZARD
Attach tubing clamp using existing hole only. DO NOT
drill into the refrigerator.
AVERTISSEMENT
Fixez le collier de serrage dans le trou présent seulement.
NE PERCEZ PAS dans le réfrigérateur.
ADVERTENCIA
Adhiera la abrazadera de la tubería usando el agujero
existente únicamente. NO perfore el refrigerador.
Raccordez l'appareil à une
Realice la conexión a un
RISQUE DE DÉCHARGE
ÉLECTRIQUE
PELIGRO DE DESCARGA
ELÉCTRICA
Shut off the main water supply.
Turn on the nearest faucet long enough to clear the line
of water.
between the water valve and cold water pipe in a
basement or adjacent cabinet. The shut-off valve
should be located where it will be easily accessible.
Turn on the main water supply and flush debris. Run
about a quart of water through the tubing into a bucket.
Shut off water supply at the shut-off valve.
NOTE: Saddle type shut-off valves are not recommended
but are included in many water supply kits. Before
purchasing, make sure a saddle type valve complies with
your local plumbing codes.
NOTE: Commonwealth of Massachusetts Plumbing
Codes 248CMR shall be adhered to. Saddle
valves are illegal and use is not permitted in
Massachusetts. Consult with your licensed plumber.
Route 1/4" OD copper or SmartConnect
(WX08X10006) plastic tubing between house cold
water line and the water connection location at the
front of the unit.
™
SmartConnect
Refrigerator Tubing Kits are available.
One 8' (2.4m) water line (WX08X10006) is needed for
each unit. The waterline will be taped to the floor using
masking tape after anti-tip bracket installation.
Tubing should be long enough
to extend to the front of the
unit. Allow enough tubing to
accommodate bend leading into
the water line connection.
NOTE: The only Café approved
plastic tubing is supplied in the
SmartConnect
™
Refrigerator Tubing kits. Do not use any
other plastic water supply line because the line is under
pressure at all times. Other types of plastic may crack or
rupture with age and cause water damage to your home.
22
a shut-off valve
™
31-1000731 Rev. 1
Publicité
