Husqvarna 535RX Manuel D'utilisation page 7

Cutting attachment
WARNING:
must not rotate when you do work on it.
Make sure that the engine has stopped.
Remove the spark plug cap before you do
work on the cutting attachment.
WARNING:
attachment is not damaged. A damaged
cutting attachment can cause accidents.
Replace a damaged cutting attachment.
WARNING:
attachment. Only use the cutting attachment
with the guards we recommend, refer to
Accessories on page 29 .
To do a check of the throttle trigger lockout
1. Make sure that the throttle trigger lockout (A) and
throttle trigger (B) move freely and that the return
spring works correctly.
B
2. Push down the throttle trigger lockout and make
sure that it goes back to its initial position when you
release it.
1069 - 009 - 13.06.2023
The cutting attachment
Make sure that the cutting
Use the correct cutting
A
3. Make sure that the throttle trigger is locked at the
idle position when the throttle trigger lockout is
released.
4. Start the product and apply full throttle.
5. Release the throttle trigger and make sure that the
blades stop and stay stationary.
WARNING:
when the throttle trigger is in the idle
position, then the carburetor idle speed
must be adjusted. Refer to
idle speed on page 26 .
Stop switch
Start the engine. Make sure that the engine stops when
you move the stop switch to the stop position.
To do a check of the cutting attachment guard
WARNING:
cutting attachment guard can cause serious
injury. Refer to
operation on page 5 .
WARNING:
recommended cutting attachment guard for
the cutting attachment that you use. If an
incorrect or damaged cutting attachment
guard is installed, this can cause serious
injury. Refer to
If the blades move
To adjust the
An incorrect or damaged
Safety instructions for
Always use the
Technical data on page 28 .
7