Husqvarna 535RX Manuel D'utilisation page 24

loss of engine power, wear to engine parts and more
fuel consumption than usual.
• Clean the air filter at an interval of 25 hours, or more
regularly if you operate the product in conditions with
much dust.
To apply oil to the foam air filter
CAUTION:
special air filter oil. Do not use other types
of oil.
WARNING:
The air filter oil can cause skin irritation.
1. Put the foam air filter in a plastic bag.
2. Put the oil in the plastic bag.
3. Rub the plastic bag to supply the oil equally across
the foam air filter.
4. Push the unwanted oil out of the foam air filter while
in the plastic bag.
To lubricate the bevel gear
1. Remove the cutting equipment.
2. Put the product with the grease plug at its highest
position.
24
Always use Husqvarna
Put on protective gloves.
3. Remove the grease plug.
4. Look into the grease plug hole and turn the drive
shaft. The grease level (A) must be in level with the
top of the gear cogs (B).
A
5. If the grease level is too low fill the bevel gear with
Husqvarna bevel gear grease. Fill slowly and turn
the drive shaft as you apply the bevel gear grease,
stop at the correct level (B).
CAUTION:
grease can cause damage to the bevel
gear.
6. Install the grease plug.
To attach and remove the locknut
WARNING:
protective gloves and be careful around the
sharp edges of the cutting attachment.
A locknut is used to attach some types of cutting
attachments. The locknut has a left thread.
• To attach, tighten the locknut in the opposite
direction to the direction of turning of the cutting
attachment.
• To remove the locknut, loosen the locknut in the
same direction as the cutting attachment rotates.
B
An incorrect quantity of
Stop the engine, use
1069 - 009 - 13.06.2023