Festool VAC SYS SE Guide D'utilisation page 12

Rotate the suction plate
Unscrew the rotary knob [7-1].

Turn the suction plate [7-2] to the required po-

sition.
Clamp the suction plate by turning the rotary

knob [7-1] as required for the task in hand.
If required, allow the suction cup with attached

workpiece to rotate during work.
7
7-1
12
1
2
7-2
Change or Replace the suction plate
Suction plates are available in different shapes

and sizes as accessories, allowing for a wide va-
riety of work pieces.
Position the suction plate in a vertical position

as shown in [6].
Unscrew the rotary knob [8-1].

Pull out the locking pin [8-2] and rotate approx.

90°.
Pull off the suction plate [8-3] while turning.

Insert new suction plate with the ribs on the

suction plate resting on the clamping unit.
Turn the locking pin [8-2] until it engages.

Please verify whether pin is tightly secured.
Clamp the rotary knob [8-1].

8
8-1
8-2
1
2
3
4
8-3