JVC TK-C1460 Manuel D'instructions page 34

MENU SETTING
MOTION DETECT Screen
Settings are executed about the motion detecting function that emits alarm signals when
there exists any motion in the image. Alarm signals are output from the auxiliary terminals on
the back.
Item
This sets ON/OFF of motion detecting function.
MODE
OFF:
ON:
LEVEL This sets the level that detects motion.
If the item MODE is set to OFF, "- - -" will appear, and
settings cannot be changed.
To function with large signal level change...decrease the
value
To function with small signal level change...increase the
value
[Set values: –5 to NORMAL to 5]
This sets the range in which the motion detecting function
AREA EDIT
works.
(
ALARM TIME
This sets the output time of the alarm signal output of
AUX terminal as well as "ALARM" display on the screen
when motion is detected.
If the item MODE is set to OFF, "- - -" will appear, and
settings cannot be changed.
[Set values: OFF, 5s, 6s, 7s, 8s, 9s, 10s, 15s, 20s, 30s,
1min]
Even when the ALARM TIME item is set to OFF, an alarm
signal is output from the AUX terminal for about 500ms,
and "ALARM" is not displayed on the screen.
This is used when checking and confirming the set motion
DEMONSTRA-
detecting function. The detection area is shown in gray.
TION
(
E-34
All manuals and user guides at all-guides.com
Functions and set values
Motion detecting function does not work.
Motion detecting function works.
Page 39)
MEMO
Page 39)
Initial value
OFF
NORMAL
–
10s
–