JVC TK-C1460 Manuel D'instructions page 30

MENU SETTING
ALC SETTINGS Screen (Continued)
Item
This function sets the colour modes to colour or B&W.
B&W COLOUR
MODE ..... When switching the mode between "colour' and "B&W" is
carried out, the focus may be dislocated. In such a case
adjust the focus again.
Switches the mode from colour to B&W and visa-versa.
B&W
OFF
ON
AUTO : The camera automatically switches to Colour
AUX
• If AUTO is selected as the B&W item, the B&W/COLOUR
setting can be switched as appropriate according to the
brightness of the object, but illumination and screen
conditions may make this impossible. Moreover, when
you use infrared illumination, if the subject excessively
reflects, a B/W screen can switch to a color screen. To
make absolutely certain of B&W/COLOUR switching,
set to AUX and input the control signal to the AUX
terminal.
• If AUX is selected as the B&W item, the AUX TERMINAL
item is automatically set to B&W IN. If this changes to
anything other than AUX, the AUX TERMINAL item
reverts to the value set before the change was made.
(
LEVEL When the "B&W" function is set to "AUTO", this function
sets the signal level of the object at which the camera will
automatically switch to B&W mode.
LOW
NORMAL: Switches to B&W mode when the signal level of
HIGH : Switches to B&W mode when the signal level of
When the item "B&W" is set to other than AUTO, "- - -" is
displayed and the settings to the item "LEVEL" cannot be
varied.
E-30
All manuals and user guides at all-guides.com
Functions and set values
: Turns the B&W mode switching function off.
: Sets the camera permanently to B&W mode.
mode when the object is bright and B&W mode
when it is dark. (
: B&W/COLOUR switching is carried out
according to the signal input from the AUX
terminal. ( Page 41)
MEMO
Page 33.)
: Switches to B&W mode when the signal level of
the object indicates low illumination.
the object indicates medium illumination.
the object indicates high illumination.
MEMO
Page 40)
Initial value
AUX
NORMAL