JVC TK-C1460 Manuel D'instructions page 33

Item
For setting the signal input or output of the AUX terminal.
AUX
TERMINAL
MOTION:
B&W OUT: A signal is output when the camera switches
B&W IN:
MEMO
• In setting B&W OUT, if you use an infrared illuminator in
link motion, hunting can occur. To prevent this, we
recommend that you link in motion this unit and the
infrared illuminator, etc., by control signals after setting
to B&W IN.
• If the B&W item is set to AUX, the AUX TERMINAL item
changes to [B&W IN] and can not be changed.
This function sets the maximum zoom ratio of the
D-ZOOM
electronic zooming.
MAX
[Set values: x1, x2, x4, x6, x8, x10]
MEMO
• The electronic zoom function can only be used by the
communication command of exclusive controllers (RM-
P2580, etc.).
• Note Picture quality deteriorates under electronic
zooming as it is accompanied by digital image
processing.
• When the electronic zoom magnification ratio is
increased, there may be blurring in the upper center left
of the screen. This is a characteristic of the main unit
and is not a malfunction.
All manuals and user guides at all-guides.com
Functions and set values
A signal is output if there is a change in the
area set on the MOTION DETECT screen.
to B&W or Colour mode.
Set to this position when inputting the B&W/
Colour switching control signal to the AUX
terminal. ( Page 11, 30.)
Initial value
(B&W IN)
x2
E-33