Temperature; Io Link Variant Config - Balluff BTL6-U101-M Série Notice D'utilisation

BTL6-U101-M _ _ _ _ -A/B/Y/Z-S4
Magnetostrictive Linear Position Sensor – Rod Style
6
IO-Link interface (continued)
6.6.7

Temperature

The following temperature values are output by the BTL as
signed 8-bit values with the unit °C:
– Current temperature (subindex 1)
– Maximum temperature since power-up (subindex 2)
– Minimum temperature since power-up (subindex 3)
– Maximum temperature over the entire lifetime
(subindex 4)
– Minimum temperature over the entire lifetime
(subindex 5)
The temperature sensor detects the
temperature within the BTL. This is always
higher than the ambient temperature.
6.6.8

IO Link Variant config

This parameter should only be used for initial
parameterization of another device variant.
Using this parameter, the IO-Link variant or device
configuration can be adjusted (see section Process data
(PD) on page 14). Access takes place via subindex 0
with an 8-bit unsigned integer value.
The following device variants can be selected:
Value Product name Device ID
0x00 BTL6-U100-... 0x030200
0x01 BTL6-U101-... 0x030201
2)
0x02 BTL6-U102-... 0x030202
0x03 BTL6-U103-... 0x030203
0x04 BTL6-U104-... 0x030204
0x05 BTL6-U105-... 0x030205
0x06 BTL6-U106-... 0x030206
0x07 BTL6-U107-... 0x030207
ABYZ stands for the respective housing style
1)
Standard variant, see Tab. 6-1
2)
Tab. 6-8: Parameters of the different
BTL6-U10_-... IO-Link device variants
This parameter changes the device's basic
communication settings. Changing parameters
automatically triggers a device restart; the
corresponding error messages in the superior
system must be accepted.
The parameter is not reset to factory settings
via the Factory Reset function (see section 6.5).
www.balluff.com
Product ID Transfer rate
1)
BTL6ABYZIOL000 COM3
BTL6ABYZIOL001 COM3
BTL6ABYZIOL002 COM3
BTL6ABYZIOL003 COM3
BTL6ABYZIOL004 COM2
BTL6ABYZIOL005 COM2
BTL6ABYZIOL006 COM2
BTL6ABYZIOL007 COM2
Due to the special functionality, the parameter is not listed
in the IO device description (IODD) and is not intended for
data storage. For operation in a special IO-Link variant,
Compatibility Mode is supported between the individual
variants (see Basic knowledge about IO-Link on
page 12).
Amount of process Min. cycle
data device – master time
0x83 (4 bytes) 0x0A (1 ms)
0x87 (8 bytes) 0x0A (1 ms)
0x8F (16 bytes) 0x0F (1.5 ms)
0x9F (32 bytes) 0x14 (2 ms)
0x83 (4 bytes) 0x28 (4 ms)
0x87 (8 bytes) 0x3C (6 ms)
0x8F (16 bytes) 0x47 (9.2 ms)
0x9F (32 bytes) 0x60 (14.4 ms)
english 17