Publicité
Les langues disponibles
Les langues disponibles
-
Switch off device when it is not
needed. Diodes are switched on
and can wear out even if there is
no visible laser output.
-
Keep the device dry. Protect it
from moisture, rain and damp.
•
The devices of Ecoline, Evolution,
Club and Proline Series are not
meant for professional applica-
tions. After approx. one hour of
operation, the device should cool
down for about 15 minutes.
•
Please ensure the fans and hea-
tsinks are clear from dust and
debris otherwise the risk of over-
6. Warnings and other notices, device connetctions & setting options
Laser radiation!
Avoid exposure
to beam
Laser class 3b
Caution of ra-
diation if cover
is removed
laser
aperture
heating may occur. If the unit and
airways appear to be blocked then
please contact a qualified service
engineer to maintain and service
the product.
•
Switch off device when it is not
needed. Diodes are switched on
and can wear out even if there is
no visible laser output.
•
Removal of the warranty label
as well as damages to the device
caused by improper handling,
neglect of the safety instruc-
tions and service notes will void
the warranty.
Model type
On / off
switch &
modes
Connection for
Sensivity
control of the
power supply
music mode
Control of the
flashing frequen-
cy in strobo mode
7. Operation
7.1 Power supply
Connect your EL-Micro with the line adapter and connect it with the power supply.
Please make sure that you are using the correct voltage. False voltages could des-
troy the device. Please use the voltage specified at the end of this manual. Don't
focus the front of the laser on people while installation.
7.2 Switch on / off
Set the switch on the back side of the laser on "On" to switch the device on or "Off"
to switch the device off. The auto mode is active when "On" is set.
7.3 Stroboflash
Set the switch on "Stroboflash" to activate the flash effect. The laser output will be
interrupted in certain intervals. Fine tuning will be made by the trim pots.
7.4 Voice Controller
The music mode is active when "Voice Controller" is activated. Fine tuning can be
made by the trim pots.
7.5 Trim Pots
There are 3 trim pots on the back side of the device: "Voice Controller Stroboflash",
"Auto Stroboflash" and "Motor Speed Controller".
7.5.1 Voice Controller Stroboflash: If your device is in the music mode you can con-
trol the sensivity of the micro with the trim pot "Voice Controller Stroboflash". Thus
it is possible to adapt the EL-Micro to the music or other sounds.
7.5.2 Auto Stroboflash: With the trim pot "Auto Stroboflash" you can set the speed
of the flash effect.
7.5.3 Motor Speed Controller: You can set the movement of the pattern of the laser
effects with the "Motor Speed Controller".
Warranty
label
Output power
& wavelength,
etc.
Micro
Speed control
of the effect
movements
Publicité
