Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
The green LED „DOOR shows the status (door opened).
Connect an optional magnetic switch to each code lock (DOOR
SENS) to monitor the open or closed state of the doors. If door 1 is
open then door 2 is locked and vice-versa.
Output 2 is not needed here and can be used for other purposes
(e.g. for an alarm system).
Check once more that all the cabling is correct.
Now connect the main power supply to your code lock.
After about 2 seconds the yellow „MAIN" LED begins to blink. Now,
close the cover carefully again.
If this does not be the case or any other type of fault occur, immedi-
ately switch off the power supply and double-check all your connec-
tions. Use the „Troubleshooting" checklist towards the end of these
Instructions.
Programming
You can now program your code lock to suit your personal require-
ments. This chapter explains all the programming possibilities.
☞
You should not take longer than 10 seconds between
each keypad operation, otherwise the previous keypad
entries will be deleted.
55
Publicité
