Marshall CODE25 Mode D'emploi page 12

GUITAR TUNER
Pressing the PRE FX and AMP Section Switches (#14 & #15 in this manual) together
accesses the guitar TUNER:
• Pluck a string and the note you are playing will display.
• Tune the string until the name of the note you wish to tune to appears on the screen.
• Arrows to the left of the vertical line means the note is flat; arrows to the right of the
vertical line means the note is sharp.
• When the arrows disappear, that string is tuned to the displayed note.
• Press EXIT/STORE to exit the Tuner.
FACTORY RESET
Performing a factory reset will return CODE's Presets back to when it was new.
Before performing a factory reset, be sure that you want to overwrite all of your personal
!
Presets.
To perform a factory reset:
• Power OFF the amplifier using the ON/OFF switch (#13 in this manual).
• Whilst holding down the AMP Section Switch, turn the power ON.
• The screen will display a notification that the amplifier is about to be returned to its
factory settings.
• If you are sure that you want to perform a factory reset, press and hold the EXIT/STORE
switch to confirm.
• If you do not want to restore the factory presets, pressing any other switch will cancel the
factory reset operation and boot the amplifier as normal.
All manuals and user guides at all-guides.com
A: >>|<<
A: >>|<<
ENGLISH
DECLARATION OF CONFORMITY
Manufacturer:
A: >>|<< A: >>|<< A: >>|<<
Kind of equipment:
Type designation:
We, Marshall Amplification Plc, declare under our sole responsibility that the above listed products complies with the following
Directives:
1. EMC Directive 2014/30/EU;
2. Low Voltage Directive (LVD) 2014/35/EU;
3. R&TTE Directive 1999/5/EC.
The following harmonised standards have been applied:
1. EMC
2. LVD
Health &
Safety
(Article 3(1)(a))
3. R&TTE EMC
(Article 3(1)(b))
Spectrum
(Article 3(2))
Signature:
Name of the responsible party:
Address of the responsible party:
Telephone number of the
responsible party:
Name of equipment:
Model No.:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
Marshall Amplification Plc,
Denbigh Road,
Bletchley,
Milton Keynes,
Bucks,
United Kingdom
MK1 1DQ
Audio Equipment
CODE25, CODE50
• EN 55013:2013
• EN 55020:2007+A11:2011
• EN 61000-3-2:2014
• EN 61000-3-3:2013
• EN 60065:2014
• EN 62479:2010
• EN 60065:2002 + A1:2006 + A11:2008 + A2:2010 +A12:2011
• ETSI EN 301 489-1 V1.9.2:2011
• ETSI EN 301 489-17 V2.2.1:2012
• ETSI EN 300 328 V1.9.1:2015
Name: B. Moon
Jam Industries USA, LLC
1649 Barclay Blvd, Buffalo Grove, IL 60089, United States of America.
800-877-6863
MD116D Guitar Amplifiers
CODE25, CODE50
ENGLISH
Date: 2nd May 2016
16