Vorlage_Layout 1 01.05.14 11:17 Seite 3
Safety Rules
Read the operating instructions before using
the tool and always observe the safety rules. Save
these instructions and give them to persons that have
not been instructed before they use the tool.
Do not open the unit and do not put
a damaged unit into operation. Do not drill into the
casing, e.g., to attach a company label. Before any
work on the unit, pull the mains plug.
the power cord regularly. Do not operate
the unit when the power cord is damaged. Always
have a damaged cord replaced through a specialist.
Do not wrap the cord around the unit and protect it
from oil, heat and sharp edges. Do not carry the unit
by the cord and do not use the cord to pull the plug
from the outlet.
dry. Store the unit in a dry location when not in use.
Consider the weather conditions. Do not work in wet
sanitary facilities. Avoid body contact with groun-
ded cables or surfaces, such as pipes, radiators,
ranges and refrigerators.
Connect power tools that are
used in the open via a residual current cir-
cuit breaker (RCCB).
Do not work in a potentially
explosive environment. Check the surrounding
before starting to work. Do not work on fuels or gas
containers or in their vicinity, even when they are
empty.
Inspect the work area before starting to
work and in case of doubt, abstain from using the
hot air tool. Do not point the unit at the same spot for
extended periods.
- 3 -
at all times during operation. When allowing the
switched off unit to cool down, always place it down
vertical and standing. Allow the unit to cool down
completely.
lop and keep suitable fire-extinguishing means at
hand.
Check
Avoid breathing in vapours, even when they
appear to be harmless. Always provide for good
ventilation of the work area or wear a respirator.
away from the unit. Do not touch the tube of the hea-
Keep the unit
ting element or the nozzle when they are hot. Do not
use the unit as a hair dryer; it develops much more
heat than a hair dryer. Do not use the unit to heat up
fluids or to dry objects or materials that are
destroyed through the influence of hot air.
when connecting the unit to the mains supply. Switch
the unit OFF when the thermal relay has actuated.
accessories for your model that are listed in these
operating instructions.
unit when it is placed down horizontally or when
pointed downward. The air-intake opening and the
nozzle must not be covered. Use only nozzles that
are suitable for your unit.
friendly recycling.
The unit must be supervised
Be prepared for flames to deve-
Keep children and other persons
Make sure that the switch is set to OFF
the hot air tool out of the reach of children
The unit, accessories and packag-
ing should be sorted for environmentally-
Use only original
Keep
Do not operate the