PERFECTPRO DAB+MATE Mode D'emploi page 24

Automatically updating the clock
Your radio will normally update the clock automatically using the DAB or FM signal. If no signal is
available, then you need to set the time manually. After a power failure the radio will then set its
clock the next time that you turn on the radio in DAB or FM mode. Alternatively you may specify that
the time is not automatically updated. In this case the clock must always be set manually after a
power interruption.
1. With your radio switched on, press and hold the Info/Menu button to access the menu for the current
mode.
2. Rotate the Tuning control knob to select "System" and press the Tuning control knob to enter the
system settings menu.
3. Rotate the Tuning control knob to select "Time". Press the Tuning control knob to enter the time
setting menu.
4. Rotate the Tuning control knob to select "Auto update" and press the Tuning control knob to enter
the setting.
5. Rotate the Tuning control knob to choose an update option from "Update from Any" "Update from
DAB" "Update from FM" or "No update" as required. Press the Tuning control knob to confirm your
choice.
Note:
If you select "Update from Any", "Update from DAB", "Update from FM" the current time received will
be displayed. If no signal is found you should either position the radio or its aerial so that a signal
can be received, or revert to manual clock mode.
22