cecotec CONGA 7290 ETERNAL HOME GENESIS Manuel D'instructions page 59

High-efficiency filter. Fig. 14:
- The high-efficiency filter is designed with fibres that help trap dust particles, dust mites,
pollen... It is very important to periodically clean the filter, to avoid these particles from
building up in the filter, causing efficiency loss. It is convenient to carry out this maintenance
once a week.
- Replace the high-efficiency filter every 3 months, depending on the frequency and type of
use.
Recommendation
You can remove dirt from the high-efficiency filter with a small brush or gently shake the filter
on a hard surface to remove the dust. The high-efficiency filter cannot be washed.
Mesh primary filter and sponge filter
The filtering system is featured with a primary mesh filter and a sponge filter, located next to
the high-efficiency filter. It is suggested to replace them either after a maximum of 160 hours
of use or when they are worn out due to operation.
Recommendation
Dirt can be removed with a small brush or by shaking carefully against a hard surface for dust
to fall off. You can also use warm water without detergents to obtain better results. Always
make sure they are completely dry before installing them again; otherwise, moisture can reach
the robot vacuum cleaner's motor and damage it.
Cleaning the fall-detection sensors
Use a clean, dry and soft cloth to wipe off any dust from the fall-detection sensors located on
the robot vacuum cleaner's lower part.
Sensors
- The robot vacuum cleaner has different types of sensors, for example, proximity sensors
that allow the robot to move around while detecting obstacles, or fall-detection sensors
that help the robot detect slopes or possible gaps/unevenness such as staircases. These
sensors are always in contact with dust particles, and therefore can deteriorate over time,
causing possible navigation errors.
- It is recommended to clean all sensors of the robot vacuum cleaner every 35 hours of use
or less, using a soft, dry cloth.
Self-emptying base
Likewise, the self-emptying base includes charging terminals and the signal transmission
zone. Use a clean, dry, soft cloth to wipe dust from these areas.
CONGA 7290 ETERNAL HOME GENESIS
ENGLISH
59