Publicité
Les langues disponibles
Les langues disponibles
TURNING THE APPLIANCE ON
Plug into the mains socket, then the appliance is standby.
Press the
button to make the appliance turn on. The last
function active when it was turned off will appear.
COOL mode
Ideal for hot muggy weather when you need to cooling and
dehumidify the room.
To set this mode correctly:
● Press the
button a number of times until the
"Cool" symbol appears.
● Select the target temperature18℃-32℃(64℉-90℉) by pressing
the △ or ▽ button until the corresponding value is displayed.
● Select the required fan speed by pressing the
Four speeds are available: High / Medium / Low / Auto.
The most suitable temperature for the room during the summer varies from 24℃ to 27℃(75℉ to
81℉). You are recommended, however, not to set a temperature much below the outdoor
temperature. The fan speed difference is more noticeable when the appliance is under Fan mode
but may not be noticeable under Cool mode.
HEAT mode *
" * " means only the heat pump model have this function.
To set this mode correctly:
● Press the
button a number of times until the Heat symbol appears.
● Select the target temperature13℃-27℃(55℉-81℉) by pressing the △ or ▽ button until the
corresponding value is displayed.
● Select the required fan speed by pressing the
Four speeds are available: High / Medium / Low / Auto.
● Water is removed from the air and collected in the tank.
● When the tank is full, the appliance shuts down and "
The tank cap must be extracted and emptied. Run off all water left into a basin. When all the
water has been drained, put the cap back in place.
● When the tank has been emptied, the appliance starts up again.
N.B.: - When operating in very cold rooms, the appliance defrost automatically, momentarily
interrupting normal operation. During this operation, it is normal for the noise made by
the appliance to change.
- In this mode, you may have to wait for a few minutes before the appliance starts giving
out hot air.
- In this mode, the fan may operate for short periods, even though the set temperature has
already been reached.
FAN mode
When using the appliance in this mode, the air hose does not
need to be attached.
● Press the
button a number of times until the "Fan" symbol
appears.
● Select the required fan speed by pressing the
Three speeds are available: High / Medium / Low.
The screen display "
DRY mode
Ideal to reduce room humidity (spring and autumn, damp rooms rainy periods, etc).
In dry mode, the appliance should be prepared in the same way as for cool mode, with the air
exhaust hose attached to enable the moisture to be discharged outside.
To set this mode correctly:
TCL Air Conditioner Service Manual
" as high speed, "
" as medium speed, "
button.
button.
" (full tank) appears on the display.
button.
14
" as low speed.
Publicité
